Duaer

Integrations

Use Webhook in Duaer

In Duaer, Webhook starts a workflow when a request reaches its URL.

Start a Duaer workflow with Webhook

For a walkthrough with examples, refer to Receive a request with Webhook in Duaer.

  1. On the Duaer canvas, open the node panel, search for Webhook, and add it as the first node.
  2. Under Authentication, choose Basic Auth, Header Auth, JWT Auth, Duaer User Auth (OAuth2), or None, then pick or create the matching credential (Basic Auth, Header Auth, or JWT Auth) in Credential to connect with.
  3. Check Allow Multiple HTTP Methods, Path, and Respond on the node.
  4. If needed, select Add Option for the optional settings listed below.
  5. Select Execute step and send a test request to the node's Test URL. Publish the workflow so its Production URL starts a run for every request.

Webhook parameters in Duaer

  • Allow Multiple HTTP Methods: Whether to allow the webhook to listen for multiple HTTP methods.
  • Path: The path to listen to, dynamic values could be specified by using ':', e.g. 'your-path/:dynamic-value'.
  • Respond: When and how to respond to the webhook.

Webhook options in Duaer

Under Add Option, Webhook offers Allowed Origins (CORS), Binary File, Field Name for Binary Data, Ignore Bots, IP(s) Allowlist, No Response Body, OAuth2 Client, Only Run If, Property Name, Put Output File in Field, Raw Body, and Response Code.

Webhook URLs

Duaer gives each Webhook node two URLs. Switch between them under Webhook URLs at the top of the node:

  • Test URL: for building and debugging. Select Listen for test event; Duaer waits 2 minutes and shows the request and its data in the editor.
  • Production URL: works from publish until you unpublish the workflow. Each call is recorded under executions.

Path sets the path of both URLs. Only one published webhook can use a given path and method. Refer to Webhook common issues.

Common issues

For errors and fixes, refer to Common issues with Webhook in Duaer.

Questions

What do you set on Webhook in Duaer?

In Duaer, Webhook mainly takes Allow Multiple HTTP Methods, Path, and Respond.

Does Webhook run before the Duaer workflow is published?

Only the Test URL works while you test with Execute step. The Production URL starts runs after you publish the Duaer workflow.

Which credential does Webhook use in Duaer?

Duaer's Webhook uses Basic Auth, Header Auth, or JWT Auth, depending on the method you choose under Authentication.

In this section