Duaer

Integrations

Start a Duaer workflow with Taiga Trigger

In Duaer, Taiga Trigger starts a workflow when Taiga sends an event.

Start a Duaer workflow with Taiga Trigger

  1. On the Duaer canvas, open the node panel, search for Taiga Trigger, and add it as the first node.
  2. In Credential to connect with, pick or create a Taiga API credential.
  3. Set Project Name or ID, Resources, and Operations.
  4. Select Execute step, then cause a real event in Taiga to capture a sample. Publish the workflow so Duaer registers the webhook and starts a run for every event.

Taiga Trigger parameters in Duaer

  • Project Name or ID: Choose from the list, or specify an ID using an expression.
  • Resources: Resources to listen to.
  • Operations: Operations to listen to.

Questions

What do you set on Taiga Trigger in Duaer?

In Duaer, Taiga Trigger mainly takes Project Name or ID, Resources, and Operations.

Does Taiga Trigger run before the Duaer workflow is published?

Only while you test with Execute step. Duaer registers the Taiga Trigger webhook for production runs after you publish.

Which credential does Taiga Trigger use in Duaer?

Duaer's Taiga Trigger uses a Taiga API credential. The secret stays in the credential, not in node parameters.

In this section