Duaer

Integrations

Start a Duaer workflow with Pushcut Trigger

In Duaer, Pushcut Trigger starts a workflow when Pushcut sends an event.

Start a Duaer workflow with Pushcut Trigger

  1. On the Duaer canvas, open the node panel, search for Pushcut Trigger, and add it as the first node.
  2. In Credential to connect with, pick or create a Pushcut API credential.
  3. Check Action Name on the node.
  4. Select Execute step, then cause a real event in Pushcut to capture a sample. Publish the workflow so Duaer registers the webhook and starts a run for every event.

Pushcut Trigger parameters in Duaer

  • Action Name: Choose any name you would like.

Questions

What do you set on Pushcut Trigger in Duaer?

In Duaer, Pushcut Trigger mainly takes Action Name.

Does Pushcut Trigger run before the Duaer workflow is published?

Only while you test with Execute step. Duaer registers the Pushcut Trigger webhook for production runs after you publish.

Which credential does Pushcut Trigger use in Duaer?

Duaer's Pushcut Trigger uses a Pushcut API credential. The secret stays in the credential, not in node parameters.

In this section