Duaer

Integrations

Start a Duaer workflow with KoBoToolbox Trigger

In Duaer, KoBoToolbox Trigger starts a workflow when KoBoToolbox sends an event. It can listen for 1 event, such as On Form Submission.

Start a Duaer workflow with KoBoToolbox Trigger

  1. On the Duaer canvas, open the node panel, search for KoBoToolbox Trigger, and add it as the first node.
  2. In Credential to connect with, pick or create a KoBoToolbox API Token credential.
  3. Pick the events that should start a run, for example On Form Submission.
  4. Set Form Name or ID.
  5. Select Execute step, then cause a real event in KoBoToolbox to capture a sample. Publish the workflow so Duaer registers the webhook and starts a run for every event.

Events that start a Duaer workflow with KoBoToolbox Trigger

On Form Submission.

KoBoToolbox Trigger parameters in Duaer

  • Form Name or ID: Form ID (e.g. aSAvYreNzVEkrWg5Gdcvg).

Questions

Which KoBoToolbox Trigger events can start a Duaer workflow?

Duaer's KoBoToolbox Trigger can listen for 1 events, including On Form Submission. Pick one or more on the node.

Does KoBoToolbox Trigger run before the Duaer workflow is published?

Only while you test with Execute step. Duaer registers the KoBoToolbox Trigger webhook for production runs after you publish.

Which credential does KoBoToolbox Trigger use in Duaer?

Duaer's KoBoToolbox Trigger uses a KoBoToolbox API Token credential. The secret stays in the credential, not in node parameters.

In this section